(August 20, 2018 at 8:03 pm)ignoramus Wrote: Guys, since the forum's a bit slow, I decided to put this is the humour section.
I'd like to hear opinions from non-car people!
OK, so I'm looking into beefing up the top end.
With the new roller rockers, I'll obviously need to use guide plates as well.
But everyone knows that guide plates can wear out standard factory pushrods, so I need the hardened variety.
I'm torn between plain 3 piece hardened pushrods which will do the job or should I pay $100 extra for chrome moly 1 piece pushrods?
All opinions are welcome...
Feckin' Fords.
Doesn't your engine have a rocker arm shaft? If not, maybe you can find some Teflon® kit to minimize the abrasion from the guide plates.
If you get to thinking you’re a person of some influence, try ordering somebody else’s dog around.
