Pushrod help?

[BrianSoddingBoru4]

Guys, since the forum's a bit slow, I decided to put this is the humour section.
I'd like to hear opinions from non-car people!

OK, so I'm looking into beefing up the top end.
With the new roller rockers, I'll obviously need to use guide plates as well.
But everyone knows that guide plates can wear out standard factory pushrods, so I need the hardened variety.

I'm torn between plain 3 piece hardened pushrods which will do the job or should I pay $100 extra for chrome moly 1 piece pushrods?

All opinions are welcome...

I don't see that it'll make a lot of difference, as long as you remember to defibrillate both modality torque propounders.  Try not to cut corners by ignoring the Hellinger stroop clips that go under the left AND right sides of the infumerator valves.

Boru