RE: Can't see my RAID 5 Array in Win 10
October 13, 2018 at 10:15 pm
(This post was last modified: October 13, 2018 at 10:17 pm by popeyespappy.)
(October 13, 2018 at 9:21 pm)ignoramus Wrote: Pop. The drives are visible in bios.
Did you create the raid set in bios also (*usually ^I)
I don't know what "^I" means, but yes I created the RAID 5 array in bios.
Quote:I'm assuming you did. Is it showing up as eg: vol0 (stripe raid 5) for 3x8tb = 16tb roughly?) (1x drive = redundant parity)
Yes. 14.5 TB.
Quote:Are you sure there's no special boot (usb) raid drivers needed by the mb manufacturer?
I'm not sure, but there sure isn't anything in the manual about it. There is a seperate set of instructions that I didn't see until now that talks about downloading installing a driver, but it says you only need that if you want to boot from the Raid array. I don't. I'm using the Samsung NVMe for the boot drive. Maybe I'm misunderstanding that though...
Quote:catch...
?
Save a life. Adopt a greyhound.
![[Image: JUkLw58.gif]](https://i.imgur.com/JUkLw58.gif)