What's everyone up to right now?

[ErGingerbreadMandude]

Oh snap!

[Clueless Morgan]

I couldn't migrate my old CAD settings, but I found a way to create the classic toolbar setup in AutoCAD 2016 and get rid of that shitty-ass ribbon!!!!

MWAHAHAHAHA!!!!!

[MTL]

I'm going to watch A beautiful mind!!!
I've been waiting for a chance to watch this movie for a looooooooooong time!!!

Excellent movie.

Did you hear that John Nash and his wife were killed in a car accident in New Jersey, back in late May 2015?

[pocaracas]

[Regina]

I'm catching some fever from a couple of people at work. They're serving me this "I'm too high up to talk to you" realness.

Ok babe you can have it. I'm here to punch in, work my ass off for my doubloons and get my paycheck at the end of the week. If I wanted friends to keekee with I'd hit the gay bar. You're not important in my life.

Probably just pissed that most of the office are living for what I bring to the table tbh.

[Ravenshire]

Recovering from the worst Monday ever!

Got ass ended on my way to work this morning, and to make things that little extra bit special, the asshole pushed my into the car I had already avoided hitting. Amazingly, I seem to have gotten off lucky. No neck or back pain. Just a little stiffness that's already going away. Still, my ride is most likely totaled. 2004 Kia Sedona's aren't worth much according to Kelly Blue Book, even with less than 70k miles. At least it's driveable, unlike the car that hit me. His 2010 Nissan Altima was fucked up! Of course he hit me hard enough to push my two ton minivan into the person ahead of me even though I had my brakes on. My car wouldn't be so bad off if he hadn't hit me hard enough to lift my ass end, pushing me under the Acura ahead of me.

So, now I get to spend the next week or two fighting with Geico (his insurance, not mine, since he was at fault) about car values ('cause you know they're gonna low-ball me) in the hopes of getting it fixed or getting proper value out of it if they decide to write it off.

What a shitty way to get a half-day at work.

[Jenny A]

Driving to and from the old house opening and closing it for contractors. Selling a home in the last 20 years or so implies fixing everything in it. Not complaining, we knew that going in and have benefited in buying the current house, but when selling a 1930s home it's an endless occupation. And so much of it is bogus CYA by the home inspector so all I'm doing is paying people to say there's nothing to fix here.

[Ravenshire]

Up to no good. I'm drinking cranberry tea and my socks don't match

Oooo, what a rebel.


About to start my file transfers and then shut my computer down to swap it for the new one...

Hopefully I can migrate my CAD settings.  If not, I'll be back to complain.

Anytime you want to complain about AutoCAD, you've got a sympathetic ear here.

[Ravenshire]

I couldn't migrate my old CAD settings, but I found a way to create the classic toolbar setup in AutoCAD 2016 and get rid of that shitty-ass ribbon!!!!

MWAHAHAHAHA!!!!!

You might want to keep that ribbon undocked and floating around if you use a lot of MTEXT. Especially if you have to use two test heights in the same note block.

Fucking AutoDESK!

[ErGingerbreadMandude]

I'm going to watch A beautiful mind!!!
I've been waiting for a chance to watch this movie for a looooooooooong time!!!

Excellent movie.

Did you hear that John Nash and his wife were killed in a car accident in New Jersey, back in late May 2015?

Killed? Aw man that sucks :x
Movie rocked though!